Parquet floors can be set up on a number of surfaces, as long as they can be properly prepared. In the event you have a new building, the parquet can be adhered by you right to the plywood. Additional steps will need to be obtained to make certain the flooring adheres if parquet is installed by you on concrete. You can even install parquet over existing timber floors so long as they’re properly prepped. Tile floors can be utilized as a sub floor, but vinyl or any carpet has to be eliminated before installing the parquet. Parquet flooring is a beautiful and durable flooring option but to ensure a long-life it is most important to make sure that you properly prepare the subfloor.
Prepping Wood Subfloor
Because of this measure, we are going to focus on prepping a wood subfloor. When you possess a fresh building plywood flooring you’re ready to go, no additional steps are essential. When you really have a current timber floor you will initially have to mend any squeaks. You must fit fasteners every 6 inches into the underlying flooring joists. After this, walkover the complete floor, jumping up and down as you go, to locate any added squeaks. Add some extra fasteners if there are squeaks in the floor. Now that you have finished the fixing, you need to employ floor leveller. Flooring leveller is similar in consistency to cement, and it will stick to the timber flooring and make a totally flat level area for you yourself to paste the parquet flooring to. Start by cleansing and cleansing the floor. Then, you are going to need to pre-mix the floor leveller in buckets and after that pour it along the floor. Provided that you blended the leveller correctly, you won’t require to direct its flow. It will level itself and will automatically fill in all the regions that are low. With all the floor leveler installed and completely dry, you happen to be prepared to begin implementing the parquet and adhesive floors.
Prepping Concrete Subfloor
You first must be sure your concrete flooring is without any grease any dirt or paint. It is especially important to test moisture levels if you should be installing the floor below ground level, or when you have newly installed concrete. To test for wetness seal squares of plastic to the ground with duct tape. Implement several of the squares around the area. Leave these pieces in position for 24 to 48 hours and if condensation is found the concrete is too wet for flooring. Otherwise, you’re ready to proceed. When there is condensation, then there exists too much moisture on your concrete flooring to put in parquet surfaces. To avoid that, plywood can be installed by you over the cement to provide your-self a dry area to stick the wood to. After you have checked for moisture, you must ensure your flooring is fully level. If it’s, and your concrete continues to be sprayed or painted, you’ll be able to install the parquet directly to the concrete. Should you have some issues with the concrete floor levelling, a flooring leveler, such as that outlined in the preceding paragraph can be applied by you. You need to utilize a latex bonding agent applied to the concrete by means of a clean roller or trowel so that the floor leveller sticks to the concrete. As soon as the floor leveller dries, you are able to put down the parquet flooring.